Don’t you think men also want rings that you have made it for them? Make DIY men’s rings to gift it to your loved ones. It’s one of the coolest and the common types of jewelry that people usually love to make. You can do it using your own creativity and gift it to your loved ones. Even men love to be gifted with something creative. So why not make the DIY men’s rings and gift it to them to show your love and affection towards them. There are many ideas that you will find on the internet to make the men’s rings.
How To Make The Quarter Men’s Ring?
Things that you need: Quarter, hammer, gloves, Dremel diamond encrusted drill bit, Dremel, File (optional), and Dremel sanding wheel.
How to do it? Take out the quarter and hammer of your choice. Tap gently on its rim. But do not tap too hard or else the quarter will bend. Rotate and tap the rim so that it gets flatten so that its edge gets the right width. Hold the quarter between your fingers along with the rim. With your drill turn on the Dremel. After you have set up, everything holds the quarter to drill away. Try to make the hole as big as possible so that you can easily fit in the Dremel sand wheel inside. Now decide what you want to use. Either use a file or the sanding attachments for the Dremel. Because here you have to sand or file it until you get to the outer ring of the quarter. If you see that there are any rough spots, then you can shave them using your Dremel.
How To Make The Spike Men’s Rings?
Things you need: Two cone beads caps, ring blank that is adjustable, super//E6000 glue, and jewelry pliers.
How to do it? Twist any kind of loop if your ring blank has any using the pliers. Now separate the two ends of the ring to make it wide. Then bend each of these ends and make them flat as much as you can. On the inner top, part of the bead caps sticks the glue to one of the prongs. Now repeat the same process for the other side as well and let it dry. You are done with it. A gift to your partner as a token of love.
How To Make The Signet Ring?
Make the pattern and cut the metal form so that you can hold the wax. Then melt the candle in the form. Using the Dremel tool so that you can rough out the shapes. Then clean the carving with the help of an Exacto knife. Next, make the wooden ring blank. Cut the wood in the size of the ring and then drill a finger hole to the three fourth inch. Now use a belt sander to round the bottom of the ring and narrow the bottom of the ring. Using the wax press the cast in the Sculpey. Use the coping saw and shape the design in the shape of a square. So, use the Dremel to recess in the ring’s top. Use the hot glue and set the symbol. Your signet men’s rings are ready.